The Industrial Raspberry Pi Forum

I've read that the Connect+ feat. Codesys does not support the M-Bus module. Any chance to get meter readings into the Connect+ and Codesys, maybe through a workaround?
And can someone explain why this restriction applies? I've found a Wago solution which allows to seeing M-Bus data via Codesys,.

Thanks!

Hi user,

what makes you think that? Where did you read this?

The M-Bus gateway exists in our library, attached is an example:
Regards

Johannes

Sorry for the late feedback.
Please see here: https://revolutionpi.de/revpi-connect-codesys/
It says:

* keine RevPi Con MBus (Artikelnr.: 100281) und RevPi Con MBus VHP Gateway (Artikelnr.: 100282) Unterstützung.

Also, have a look here: https://revolutionpi.de/shop/de/mbus-module
The field of compatible extension modules does not list the M-Bus device.


I also checked it out in Codesys, I can't find any options to add it:

Hi Dirk,

Do you already have enabled the mbus module in the webinterface and updated the module setup in pictory? If not, please have look at our tutorial section.

Nicolai