Hello,

there is a post in the RevPi forum that is similar to your question. see in the link below.
viewtopic.php?t=3377

I hope I could help you with your problem

Mit freundlichen Grüßen | Best regards
Giuseppe Pagano | Technical Support

Hallo Jenny, Du könntest nochmal überprüfen, ob die Verkabelung stimmt. Verwendest du ein 2-, 3- oder 4-Draht Temperatursensor? verkabelung.png beschreibung.png belegung.png Ebenso kannst du die PiCtory Konfiguration überprüfen. Als tipp: Du könntest auch einen herkömmlichen Widerstand verwenden, di...

Hello, as I have interpreted your system, it looks like this: 4694.png can you check following steps: is PiCtory config correct? You can load the default PiCtory "Start-Config" and show if the ModbusRTU master is connected or visible Likewise you can check the configuration of the ModbusRT...

Hello Cade, @Cade: I took the liberty of summarizing your second question in your first post. EtherCAT and CANopen use comparable concepts for drive control, but the bus physics are completely different. With CANopen you are limited to 1 Mbit/s, of which about half is needed by the CAN overhead. Wit...

Hello,
I would recommend you to update Node-RED. There is a post in the forum about it:
viewtopic.php?t=3373

I hope this will solve your problem.

Mit freundlichen Grüßen | Best regards
Giuseppe Pagano | Technical Support

Hello, to configure the analog outputs, you must log into PiCtroy and make the changes there. 4736_out.png 4736_in.png additional information about the RevPi compact https://revolutionpi.com/tutorials/analoge-ein-und-ausgaenge-compact/?noredirect=en_US I hope I could help you with your problem. Mit ...

Hello,
have you saved the configuration and reset the driver, as shown in then images below? I hope I could help you

Mit freundlichen Grüßen | Best regards
Giuseppe Pagano | Technical Support

Hello,
You can try resetting your admin password.
Like on the picture below. I hope this will solve your problem.

Mit freundlichen Grüßen | Best regards
Giuseppe Pagano | Technical Support

Hallo, ihr Projekt können Sie am besten mit einem "RevPi Con Can" erweitern, um mit CODESYS über das Erweiterungsmodul Sensorwerte auszulesen und zu verarbeiten. In den folgenden Links finden Sie Informationen über den "Con Can": https://revolutionpi.de/shop/de/canbus-module http...

Hello Cade,

this topic has already been discussed in the forum entry: https://revolutionpi.com/forum/viewtopic.php?t=2203

I hope I could help you

Mit freundlichen Grüßen | Best regards

Giuseppe Pagano | Technical Support