Hello, The input module was wired to source current (0v for on, 24v for off) but I can't find any documentation confirming this is the correct wiring. The module is for 24 V compatible according to EN 61131-2 with type 2 and 2 sensors. It’s means 0 V ----> off, 24 V ---->on. 1.png Can anyone confirm...

Hello,
In the following link you will find the datasheet of the RevolutionPi AIO, below you will find the resolution and voltage ranges, as well as other data of the AIO.
Data sheet RevPi AIO

Best regards
Giuseppe Pagano

Hello,

Do you know if it's plan to have a Rust library supported by Kunbus to develop on the RevPi ? Like the librairy for Python

at the moment, this is not planned. We are currently improving the Python library.

Best regards
Giuseppe Pagano

Hello Petter, I would recommend using the Modbus RTU Gateway and configuring it as RS232 or RS485 (or RS422) . This is much easier to configure than the Serial Gateway. If you have a RevolutionPi Connect +/SE/S, you can use the front interface as RS485. RevolutionPi Connect RS485.png If you have a R...

Hello,
I know about this error. Use the linux function "scp" (make the changes locally and copy them to the Target System) or Filezille as a Winscp alternative.

Hello Steffen,
what message is displayed in the rpiboot console?
Was the device detected correctly?

Hallo,
es gibt einen Artikel darüber, wie so etwas durchgeführt werden kann.
RevPi Flat Backup and Restore Image

Hello Nils, there is no EEPROM installed on the RevolutionPi Core 3 and Connect. The data is all stored in flash. Note: if you want to spare the flash, you can store certain information (link in the above post) in RAM. The disadvantage of this is well known. The flash memory is installed on the CM3 ...

Hello,

we are not familiar with this behaviour. I have just tried this with our latest image and it all worked.
I have tried this with codesys and piTest.

Please follow the checklists below.

RevolutionPi Checklist
Codesys Checklist

I hope this will solve your problem.

Hallo, eine interessante Fragestellung. Je nach Betrachtung lässt sich in diesem spezifischen Fall für eine „0“ oder „1“ eine Begründung finden. Dass die Eingangs-Versorgungsspannung fehlt, lässt sich über die Statusbits 1 + 2, 4 + 5 erkennen. Eine Beschreibung befindet sich hier: Konfiguration digi...