I'm trying to use RevPiPyLoad to send received data from a virtual Modbus Master over MQTT to Node-Red, and also to output DMX from Node-Red using a DMX gateway. So far it's not going very well. I have followed this tutorial and configured revpipyload.conf as the tutorial prescribes. However, when I...

Got it! I think there were a few different issues at play. Some of the fields in the "extended data" had been emptied (as described in a different thread in the forum), and in an attempt to fix that I re-added the virtual master and apparently forgot to set the correct parity. And to top i...

I'm trying to get a RevPi Connect to talk to a Modbus slave connected directly to the onboard RS485 port using a short twisted pair cable. I have previously gotten the Modbus slave to work with Node-Red on the same RevPi by using a Modbus master node in Node-Red, so I know the hardware configuration...

There we go, now it worked! The terminal output was exactly the same as last time. Only difference is apparently I typed the letters in the MAC address in lowercase last time and uppercase now. Is it case sensitive?

I did that yesterday, but I can try again and see if the outcome is different this time.

Here they are:
/boot/config.txt: https://cumulus.glod.studio/s/sY83FTF3ANXrETS
/var/log/kern.log: https://cumulus.glod.studio/s/irwnMBGTDfEtKaG

Hi all, I'm about to re-commission a RevPi Connect+ to a new project, so I figured I'd do a fresh firmware install, but I'm having some issues after having installed the latest stable Buster image (2022-01-19). When opening Pictory (after having worked around the password bug), I noticed that the Re...