I've documented the EERAM's usage internally but apparently that part of the documentation hasn't found its way to the Compact Tutorials page yet: Briefly, the EERAM is exposed as a generic file called /sys/bus/nvmem/devices/1-00500/nvmem. You just need to open/read/write/close this file. Anything w...

The Con CAN option in webstatus merely loads a devicetree overlay which instantiates the CAN slave below the SPI master (and sets the status of the spidev slave to "disabled"). This looks like the RX line is pulled high. I'd suggest to double-check the wiring and verify whether the correct...

First picture shows the camera port. Second picture shows the Micro-USB port to access the eMMC. The camera port uses an HDMI connector to transmit CSI signals. To use it, you need: Raspberry Pi Camera ( HQ or V2 or NoIR V2 ) Pi Camera HDMI Cable Extension (adapts CSI signals to HDMI interface) HDMI...

How about configuring netfilter rules to set up a firewall on the PiBridge Ethernet? You should also be able to talk to a neighboring Core with RS485 by opening /dev/ttyAMA0 on each of them with miniterm or something like that. Instead of cutting away the Ethernet pins, you can just shut down the pi...

Yes that is possible, there are some brief notes in the stretch 3/2019 release announcement (search for "PiBridge networking"). Basically you need to comment out piControl in /etc/modules, connect the two Cores with a PiBridge plug and boot them. They will assign themselves IP addresses in...

I agree that it looks like a hardware issue. Devices on the USB bus are auto-discovered. If they don't show up, they're likely dead. Question is, did this happen out of the blue or was the chip somehow fried by feeding a too-high voltage through the RS485 port? The FTDI chip isn't connected directly...

Ja, genau. Ich habe sie schließlich dazu gebracht, das zu fixen (siehe hier ) und sie haben's natürlich erstmal bezweifelt, wollten "evidence" sehen. Nachdem sie dann die Warnung beim Booten entdeckten, haben sie's geglaubt. Sie haben dann ein neues Paket vom Bootloader released, aber nur ...

I have a MODBUS RTU Master in my RevPi connect, with only 5 actions defined. There is 3 slaves attached, the wiring is all twisted Pair CAT5 via a distribution PCB and short stubs of like 20cm to each device. Total cable length is around 1m estimated. The bus is terminated at the RevPi and on the d...

Wenn wir das machen würden und der Benutzer löscht das teamviewer-revpi Paket, dann kann er es nicht mehr re-installieren. Weil die Paketquelle nicht mehr bekannt ist. Genau aus dem Grund ist es auch Unsinn, dass die Paketquelle in dem teamviewer-revpi Paket drin ist.

Das Problem ist, dass das teamviewer-revpi Paket zwei Dateien nach /etc/apt installiert, die unter anderem Namen auch in unserem revpi-repo Paket enthalten sind. Wir haben auf das teamviewer-revpi Paket keinen direkten Einfluss. Das Paket wird von TeamViewer auf einem eigenen apt Server bereitgestel...